Feb 29, 2024 · With everything connected (including UTC, M84 and Arduino), what resistance do you measure between CAN Hi and CAN Lo? What do you measure when the UTC is removed?

Aug 6, 2025 · Is it necessary to connect a 120-ohm resistor to the CAN analyzer device? That depends on resistance of the CAN lines. Measure the resistance across CAN_H and CAN_L with the power …

Apr 30, 2020 · I would use a 120 ohm resistor at the plex dash connector and another at whatever device is at the other end of the bus. Be aware that the UTC has a built-in terminating resistor so the …

Please note: for MoTeC M84 ECU to communicate with aim loggers a 120 Ohm “line end” resistor is needed. Ensure that it is installed between CAN+ and CAN-; use a multimeter; disconnect AIM …

Feb 10, 2017 · The AEM CD-7 has a software selectable Terminating resistor within the display. If the CD-7 is located at one end of the network then you can use this internal terminating resistor, …

Aug 10, 2021 · - make sure you terminate the M84 end with a 120 ohm resistor (literally just wire one between the 2 CAN wires where they come out of the ECU) In Racecapture the common settings are:

The sensor contains a temperature dependant resistor and is designed for high speed response in an air flow. The Air Temp sensor must be placed to measure the air temperature before the butterfly (and …

A resistor in which a sliding or rolling contact moves over an exposed area of the resistive element to change the ohmic value of the output. The functional tolerance (linearity) of the output is equal to or …

For MTU original engine parts MTU 12V 2000 M84, including the 0001583645 RESISTOR, we recommend requesting real-time availability to ensure prompt and accurate service. If you cannot …

Home » Catalog » Electrical (p. 15126) » Pre Wire Wound Variable Resistors (p. 80) » Part Number 75-M84