Water might seem soft and harmless, but under the right conditions, it becomes one of the most powerful natural forces on Earth—powerful enough to slice straight through solid rock! In this ...

It focuses a laser-cutting beam using a stream of lowpressure water. The water guides the laser using total internal reflection at the air/water interface, similar to how fiber optics transmit light.

After much experimentation, he stumbled upon a simple solution: submersion under a thin layer of water was sufficient ... a little deeper. The CO2 laser cutter is a very versatile tool, capable ...

Water jet cutters used to take up most of a ... Wazer is gearing up to do what Glowforge did for laser cutters and what Formlabs did for SLA 3D printing: making available to everyone high-end ...

something not normally possible with the laser cutters within our reach. A water cutter is something you might think would be impossible for an experimenter to make for themself, but [Applied ...

Depending on the average temperature of the environment in which the laser cutter will be operating you'll need a certain amount of antifreeze (included in the box) mixed with purified water (you ...

Laser cutters like the xTool P2 cut away material ... so part of the initial setup is filling a reservoir with antifreeze and water. Use distilled water, not tap water. The impurities in tap ...

CO2 laser cutting and etching machines have been around ... hose out a nearby window for the smoke and then set a bucket of water next to the laser and dangle some cooling hoses down into the ...